Knowledge base

Guides

How to pick the right replacement carbon finger, what to check before you order, and how we mark the difference between what we have verified and what a buyer has told us.

What every guide here contains

A specification table with a source column — measured data is never mixed with estimates.
A compatibility table that separates verified, customer supplied and to be confirmed.
Links to the specific products discussed, plus a direct route to a quotation.
Image slots reserved and labelled. Where a photo is still missing we say so rather than substituting a drawing.

Product photography for these guides is still being produced — every image slot below is marked with what it needs. Nothing on these pages is illustrated with stand-in artwork.

Selection guides

How to choose the right part — dimensions, threads and machine model fitment.

Selection guide

How to Choose a Replacement Carbon Finger

The four numbers that decide whether a finger fits: shaft diameter, overall length, thread size, and the machine model. Includes the full size chart for our current range.

8 min read Size chart Compatibility table Read the guide →

Troubleshooting & application

What goes wrong, what to check on the machine, and what we will not claim without data.

Troubleshooting

5 Carbon Finger Mismatches That Cause Returns

Wrong thread, stamped length mistaken for total length, brand assumed across a range, keywords read as fitment, and rod length used as finger length — with the check that prevents each.

7 min read Mismatch table Pre-order checklist Read the guide → Application

When to Replace a Carbon Finger

Worn finger versus damaged mount: two different failure modes needing two different responses, plus the machine checks to run before you order.

6 min read Failure modes Model compatibility Read the guide →

Planned next

Framework is in place — these slots fill against the same standard, one article at a time.

Selection guide

Thread family reference: M6 / M8 / M12

A single-page cross-reference of every thread interface in the range, once all interfaces are confirmed.

Awaiting data confirmation

Selection guide

PELLENC OLIVION fitment walkthrough

Model-by-model matching for P230 / T220 / T300, expanding CF-07 buyer data into a full guide.

Awaiting photography

Application

Season preparation and stock planning

For dealers: what to hold in stock ahead of a harvest, and how to record confirmed specs per machine.

Planned

Still not sure which part fits?

Send the machine model and a photo of the original part — we confirm the match before you order.

WhatsApp us

Fastest route: machine model + one photo of the original part